Bathroom wall "Hietakari VETRO 548"

Finnish bathroom partition manufacturer Hietakari was founded in 1993 by Tuula Hietakari in Naantali, Finland. While expanding its products, Hietakari specialists carefully nurture the idea that the range always remains fashionable and high-quality. In 2018, the brand was awarded the Design from Finland label, which demonstrates its commitment to the best Nordic design values ​​- high quality, responsibility, environmental friendliness and timeless design. The pillar of quality is based on production control and production management, which are fully computerized using proprietary software. Products are thoroughly tested in our factory's test facilities, which far exceed CE quality standards.

GLASS
The shower cabin is equipped with 8 mm thick tempered glass.

FITTINGS
Profiles made of brass alloy are installed at the edges of the shower enclosure.

INSTALLATION
The shower enclosure and door are attached to the walls using a fitting and hinges. The fixed wall is supported from the upper edge on a bracket bar installed in the corner, and from the lower corner – on a fitting glued to the floor. There will be a 25 mm gap between the glass of the fixed wall and the floor. It is possible to install a seal to prevent water from entering under the glass

DIMENSIONS
L1 side: 90.3 cm. (A-40.5 cm; B-49.8 cm)
L2 side: 90.3 cm. (A-40.5 cm; B-49.8 cm)
Height: 200 cm.