Bathroom wall "HIETAKARI FORMA 382"

Finnish bathroom partition manufacturer Hietakari was founded in 1993 by Tuula Hietakari in Naantali, Finland. While expanding its products, Hietakari specialists carefully nurture the idea that the range always remains fashionable and high-quality. In 2018, the brand was awarded the Design from Finland label, which demonstrates its commitment to the best Nordic design values ​​- high quality, responsibility, environmental friendliness and timeless design. The pillar of quality is based on production control and production management, which are fully computerized using proprietary software. Products are thoroughly tested in our factory's test facilities, which far exceed CE quality standards.

GLASS
The shower door is fitted with 6mm thick tempered glass, which is partially opaque and has a texture on one side and a smooth side on the other.

FITTINGS
The shower door opens outwards at an angle of 90 degrees. The door is installed with profiles made of aluminum and covered with an anodized coating. The profiles are sandblasted before anodizing to make the surface as smooth as possible and to prevent fingerprints. The fittings used in the product are made of brass alloy and have a chrome finish.

INSTALLATION
The shower door and wall magnet are attached to the wall using wall profiles. The door has adjustable centering. The installation height is freely selectable. To prevent water leakage, it is recommended to install the product close to the floor and install a floor seal along the bottom edge.

DIMENSIONS
L1 side: 88.9 – 91.9 cm.
Height: 202.5 cm.